How to Use Our Flatbed Laminator?

April 11, 2020

1. Position the material in the center of the working table.

Zhengzhou Mefu CNC Equipment Co., Ltd.

2. Place the metal sheet on a section of polystyrene or similar material to stabilize the sign and distribute the pressure.

Zhengzhou Mefu CNC Equipment Co., Ltd.

3.Place the graphic on the substrate and measure to the exact size.

Zhengzhou Mefu CNC Equipment Co., Ltd.

4. Using the control button on the top of the machine, press the roller against the substrate to fix the graphic into place.

Zhengzhou Mefu CNC Equipment Co., Ltd.

5.Fold half of the graphic over the roller.

Zhengzhou Mefu CNC Equipment Co., Ltd.

6. Peel off the liner form the half that is above the roller

Zhengzhou Mefu CNC Equipment Co., Ltd.

7. Fold the liner back underneath the roller to form an even pleat, as shown in picture.

Zhengzhou Mefu CNC Equipment Co., Ltd.

8. Get the right to the edge of the liner, raise the roller slightly so that it does not roll onto the table. Make sure that the graphic is pressed against the roller.

Zhengzhou Mefu CNC Equipment Co., Ltd.

9. Slide the guide beam slightly and manually to finish the whole lamination.

Zhengzhou Mefu CNC Equipment Co., Ltd.

10. Laminated graphic

 Zhengzhou Mefu CNC Equipment Co., Ltd.

11. Trim to size if the graphic is larger than the substrate.

Zhengzhou Mefu CNC Equipment Co., Ltd.

12. The result: a smooth sign without creases or bubbles

Zhengzhou Mefu CNC Equipment Co., Ltd.